MFC-CB v1.00b Embedded Software

Download the file.

Run Winflash and select the file downloaded as the file to write to the product.

Make sure the correct COM port of the product is connected to a RS232 port on the host PC. Use a null modem cable to COM2 port of PG7000 Piston Gauge. Use a standard RS232 cable to COM1 port of PPC, PPC, RPM and molbox.

The updating of embedded software should only be performed after given specific instructions to do so from a Fluke Calibration Authorized Service Center ».

If the update isn't performed properly, your product will be inoperable until it is.

Ver 1.00a (01 Oct 25)
FIX: "VSENSE" command would not accept a suffix.
CHG: Change the units displayed on the front panel to 'V' when the ''VOUT=" command is used, and to 'mA' when the "COUT=" command is used.

Ver 1.00 (01 Aug 14)
Inital release of software for new control box for MFCs and MFMs