PPC4 v1.2.2.63 Embedded Software

Run Winflash and select the file downloaded as the file to write to the product.

Make sure the correct COM port of the product is connected to a RS232 port on the host PC. Use a null modem cable to COM2 port of PG7000 Piston Gauge. Use a standard RS232 cable to COM1 port of PPC, PPC, RPM and molbox.

If your product has an model number ending in "-AF", it requires specific "-AF" embedded software.

The updating of embedded software should only be performed after given specific instructions to do so from a Fluke Calibration Authorized Service Center ».

If the update isn't performed properly, your product will be inoperable until it is.

Ver 1.2.2.63 (2012 Mar 12)
ADD(PPC-373):Support for auto-ranging a utility sensor on future Cockpit PC software.
FIX(PPC-353):Replace DH Instruments PPC4 screen with new Fluke Calibration screen saver.
FIX(PPC-367):Jog feature in the GUI does not work.
FIX(PPC-376):GUI's AutoTest feature not working with utility sensor.
FIX(PPC-378):The ARANGE command does not work when a utility sensor is specified.
FIX(PPC-379):Cannot use or select a utility sensor in GUI autorange screen.
FIX(PPC-384):Use full resolution on the reply of the HL and SS command to ensure they do not indicate '0' when they are actually a small value.
FIX(PPC-371):ABORT command does not abort CONT measurement.
FIX(PPC-388):"Lo" pressure control mode should not use the slow down valves when ramping.

Ver 1.02 (2010 Sep 15)
ADD(PPC-319):The A14MU RPT is now supported.
ADD(PPC-334):The BA100K is now a supported QRPT.
CHG(PPC-359):The default uncertainty Span value was changed to 0.003 from 0.0024 for a Standard QRPT.
CHG(PPC-355):SI and US model PPC4s now support the same set of available Autorange values for a given QRPT. The default range values are still consistent with the SI and US model definitions. Previously a US A1000 psi PPC4 could not be Autoranged to 7MPa.
FIX(PPC-358):Setting low negative gauge pressures did not use the proper internal controller logic preventing the pressure targets from being achieved.
FIX(PPC-342):When the security level prevents changing a value, the PPC4 allows the field to be edited but did not restore it. The security protected fields are now properly restored.
FIX(PPC-327):The hold limit and stability limit values were not preserved after a power cycle unless the unit of measure, resolution or upper limit was also changed.
FIX(PPC-322):The "ARANGE" command did not work properly when attempting to auto range the BA 100K.
FIX(PPC-311):The secondary password used when the original password is forgotten, did not allow the security level to be changed.
FIX(PPC-363):Selecting the maximum resolution on the PPC4 basic interface creates a memory fault.